3 10′ PVC Pipes - (We used 1 ¼″ piping. If you use a smaller/bigger size make sure you get the correct fittings as well)
4 1 ¼″ elbows (the feet)
4 1 ¼″ tees
4 1 ¼″ 90° elbow with slip
Instructions
Cuts you will need to make!
(4) 37″ pipe cuts (legs)
(2) 60″ pipe cuts (towel bars)
(4) 17.5″ pipe cuts (side bars, top & bottom)
Once you have cut all your pieces start fitting the pipe pieces into the fittings.
You will connect the foot elbows with the 37″ pipes (the legs) and then connect 2 of the legs to one 17.5″ pipe.At this point, you should have created two large side leg pieces.
You will then connect the tees to the tops of the 37″ pieces and again connect the 17.5″ pipes to those.You will have created a rectangle and now you are ready to connect your elbows with slips.
The slip side will go down into the tees and you will connect your towel bars to the other side.